Spitzengewicht: 90-110gr, 100-120gr, 120-140gr Material: Wolfram Stahl passend für Easton X10 Schäfte im Spine 0.380 bis 1.000...

Tungsten break-off point for Skylon shafts with a 3.2 mm inside diameter, graded by spine range. On barrelled shafts the outside diameter at the point end changes with spine. This point is therefore not offered as one universal version but in several...

One piece glue-in point for aluminium shafts, with a weight that can be increased using a module. The point is hollow and takes a weight module of 10, 20 or 50 grain. Point weight can therefore be adjusted in steps without rebuilding the arrow, which...

Add-on weight that screws into Easton's Adjustable Points, available in three steps. The Adjustable Points are hollow and take a weight module. Point weight can therefore be changed without swapping the point or rebuilding the arrow. It is the quicke...

Stainless steel glue-in point for the X10 and X10 Pro Tour, with a weight that can be adjusted by breaking off pre-machined sections. The point ships at full length, which corresponds to the upper figure of the stated range. Break lines are machined ...

One piece glue-in point in nickel-plated steel for shafts in Easton component size 6.5 mm. The 6.5 mm figure is Easton's component size, not the outside diameter of the shaft. It refers to shafts that take S size components, meaning an inside diamete...

Tungsten break-off point for the X10 and X10 ProTour, adjustable in weight in two steps. Tungsten is considerably denser than steel. The same point weight therefore sits on a shorter body and further forward in the shaft. Compared with the stainless ...

One piece tungsten point for X10 shafts, with size assigned by shaft and spine. Tungsten is considerably denser than steel. The same point weight therefore sits on a shorter body and further forward in the shaft, raising FOC without carrying as much ...

One piece glue-in point in hardened, nickel-plated steel for aluminium shafts. The Bullet Point is made from a single piece: the point and the shank that sits inside the shaft are one part, with no insert and no thread. That keeps the build light and...

Please order only in multiples of 3 , ie 3, 6, 9 pieces etc, otherwise you will get an error message "invalid quantity" in the shopping cart! fits 4mm A/C/E (ACE) and ProComp shafts weight can be adjusted by breaking off segments in 10-grains increm...

Please order only in multiples of 3 , ie 3, 6, 9 pieces etc, otherwise you will get an error message "invalid quantity" in the shopping cart! fits 4mm shafts also for Carbon One (all spines) weight can be adjusted by breaking off segments...

...