Spin Vanes
Spin vanes are thin, pre-curved plastic vanes that are applied with double sided tape and wrapped at the ends. They weigh very little and set the arrow spinning quickly, which makes them the first choice in recurve target shooting.
This category holds spin vanes in various lengths and colours, each in right and left hand versions, along with the matching adhesive and wrapping tape.
Spin vane in plastic, 2 inches long (50.8 mm). Six air channels guide the flow around the blade, three more turn it inward. The arrow settles more quickly after release and runs true sooner. At 2.00 inches this is the middle size of the range, coveri...
23,95 €
Spin vane in plastic, 2.5 inches long (63.5 mm). Six air channels guide the flow around the blade, three more turn it inward. The arrow settles more quickly after release and runs true sooner. At 2.5 inches it is the largest of the range and gives th...
23,95 €
Spin vane in 1.75 inches (44.5 mm) for archers who want to keep the flight behaviour they are used to. In profile the S follows conventional vanes but takes over two solutions from the Original range. The base is curved, so it wraps onto the round sh...
23,95 €
Spin vane in 4 inches (101.6 mm) for indoor shooting and heavier arrows. The Shark carries the air channels of the Original vane but is longer and less curved. Its lower profile leaves more clearance to the arrow rest, while the surface exposed to th...
23,95 €
Tape that applies three strips at the correct spacing in one go. Nothing has to be marked out, the spacing is set by the sheet. It goes faster still with the Jet6 Triple Fletching Jig, which holds the sheet while the shaft is rolled over it. One pack...
11,95 €
Wrapping tape for the ends of spin vanes. The strips carry measuring marks, so the tape can be cut to length without measuring. One pack holds 5 sheets with 17 strips each....
11,95 €
Fluorescent wrapping tape for securing the ends of spin vanes. After the vanes have been fitted, the tape is wrapped around the shaft to protect their leading and trailing edges from lifting. The fluorescent colour also makes the securing wrap easy t...
1,95 €
Clear wrapping tape for discreetly securing the ends of spin vanes. The transparent tape is wrapped around the shaft after fletching and helps prevent the leading or trailing edge of a film vane from lifting. Note Clear and colour neutral For spin va...
1,50 €
Opaque coloured wrapping tape for securing the ends of spin vanes. Once the vanes are fitted, the tape is wrapped around the shaft to stabilise their leading and trailing edges. Its solid colour can be matched to the shaft, wrap or fletching. Note Op...
1,95 €
Lightweight 1.5-inch spin vane for recurve bows, developed as the Brady Ellison Edition. The parabolic profile generates arrow rotation for flight stabilisation. This version is 0.60 inch high and is available in RH or LH configurations to provide th...
22,95 €
Very soft and lightweight 1.5-inch spin vane for performance-oriented recurve setups. Model 702 uses a slightly taller parabolic profile than the regular Brady Ellison Edition. According to the manufacturer, each film vane weighs approximately 0.6 gr...
22,95 €
Designed to be forgiving, accurate and durable for Brady Ellison Lightweight material produces more feet per second Available in White,Gold,Silver and Blue colour Length: 1.8″ Weighs just 1 grain! (white ultra-soft = 0.6 grain) Includes ...
22,95 €


















































