Tungsten break-off point for the X10 and X10 ProTour, adjustable in weight in two steps. Tungsten is considerably denser than steel. The same point weight therefore sits on a shorter body and further forward in the shaft. Compared with the stainless ...

One piece tungsten point for X10 shafts, with size assigned by shaft and spine. Tungsten is considerably denser than steel. The same point weight therefore sits on a shorter body and further forward in the shaft, raising FOC without carrying as much ...

Hot melt adhesive with low melting temperature for gluing in points, results in a removable connection if desired (carefully heat the point and you can remove it from the shaft again) length either 3" (approx. 7,5cm) or 8" (approx. 20cm) 0,5" di...

Screw-in point with an elongated ogive, made to unusually tight weight and concentricity tolerances. Easton quotes ±0.5 grain weight variation and concentricity within .0005" for these points. That is where the extra cost is justified: on finished a...

Screw-in point with an 8-32 thread in five diameters, packed by the dozen and therefore matched to a full set of arrows. The Multi Point is the standard point in the Easton range for aluminium and carbon shafts with an RPS insert. Easton lists it wit...

Enhances durability and protects the nock end of your arrows. Easton 4mm nock collars reinforce the rear section of the shaft, helping to prevent damage from impacts while ensuring a consistent and secure nock fit. Features Protects the nock end fro...

The Easton X10 Nock Collar reinforces the nock end of X10 arrow shafts, helping protect against cracks and impact damage. Product Description The X10 Nock Collar by Easton is specifically designed for Easton X10 arrow shafts....

...

One piece glue-in point in hardened, nickel-plated steel for aluminium shafts. The Bullet Point is made from a single piece: the point and the shank that sits inside the shaft are one part, with no insert and no thread. That keeps the build light and...

aerospace aluminium pin with 3,2mm diameter allows the usage of pin nocks Pin #1 = Easton P/N 578794 - fits all  normal  X10 shafts Pin #2 = Easton P/N 197351 - fits all X10 Pro Tour shafts...

...

inkl. orangefarbener Super-Nocke und CB-Insert es passen auch Microlite Super Nocks und 3D Super Nocks sowie Beiter 19er Nocken es passen CB-Spitzen (außerdem die Schraubspitzen aus der Tabelle) Information about shortening arrows or shafts ...