Arrow puller in rubber with a grippy surface. The rubber holds the shaft without needing a hard squeeze and suits all common arrow diameters....

Slim arm guard that sits close to the forearm. The thin build leaves the string plenty of room, and the two ribs touch it only on a narrow surface. Available in several colours....

Double sided fletching tape, 10 sheets with 26 strips each. Behind the black line there is a non-sticky area for peeling the strip off the backing. The bond sets after fletching and holds firmly after 24 hours, while still coming off again when vanes...

Damper for the limbs, two pieces per pack. It mounts on the limb and takes up part of the vibration left in the bow after the release. The build is compact and adds very little weight. Available in several colours....

Elastomer damper for stabilizers and sights, five per pack. It mounts on the stabilizer or the sight and absorbs vibration there without changing the feel of the shot. Suitable for recurve and compound. Available in several colours....

Rubber spin vane in 1.88 inches (47.8 mm), developed for compound bows. The material gives way as it passes the rest and returns to shape afterwards, so no crease is left behind. Jet6 states the weight at 3.1 grains. Available as an RH or LH version....

Spin vane in plastic, 1.75 inches long (44.5 mm). Six air channels guide the flow around the blade, three more turn it inward. The arrow settles more quickly after release and runs true sooner. At 1.75 inches it is the smallest of the range and offer...

Spin vane in plastic, 2 inches long (50.8 mm). Six air channels guide the flow around the blade, three more turn it inward. The arrow settles more quickly after release and runs true sooner. At 2.00 inches this is the middle size of the range, coveri...

Spin vane in plastic, 2.5 inches long (63.5 mm). Six air channels guide the flow around the blade, three more turn it inward. The arrow settles more quickly after release and runs true sooner. At 2.5 inches it is the largest of the range and gives th...

Spin vane in 1.75 inches (44.5 mm) for archers who want to keep the flight behaviour they are used to. In profile the S follows conventional vanes but takes over two solutions from the Original range. The base is curved, so it wraps onto the round sh...

Spin vane in 4 inches (101.6 mm) for indoor shooting and heavier arrows. The Shark carries the air channels of the Original vane but is longer and less curved. Its lower profile leaves more clearance to the arrow rest, while the surface exposed to th...

Holder for the Jet6 Triple Fletching Tape. Spin vanes are applied by hand with tape, so the spacing has to be right before the first vane goes on. That is what the holder takes care of: lay in the backing sheet with the adhesive side up, put the bare...