Achtung: bitte bestellen Sie immer ein Vielfaches von 3 Stück (also 3 Stück, 6 Stück, 9 Stück etc.) sonst wird im Warenkorb die Meldung "ungültige Stückzahl" angezeigt. passend auf alle Pfeile mit UNI Bushing (Komponentengröße 00 oder Innend...

Brass insert for the 5 mm HIT system, adjustable in weight from 75 down to 50 grain. Compared with the 16 grain standard insert, brass puts considerably more weight right at the front. That raises FOC without moving to a heavier point, and it is the ...

Standard HIT insert at 16 grain for shafts using the 5 mm HIT system, with installation tool. With the HIT system the insert disappears entirely inside the shaft. The point then seats directly against the end of the shaft, and impact load travels int...

Standard HIT insert at 16 grain as a complete set with installation tool, stone and epoxy. With the HIT system the insert disappears entirely inside the shaft. The point then seats directly against the end of the shaft, and impact load travels into t...

Half-out inserts for shafts with a 5.2 mm inside diameter, in aluminium or steel. A half out sits half inside the shaft and half in front of it. The section that protrudes forms a collar protecting exactly the place where a carbon shaft is most vulne...

Hardened stainless steel reinforcing collar for the point end of shafts using the 5 mm HIT system. The collar slides over the point end and takes up the load that impact on hard targets puts on the shaft wall. That is exactly where an unreinforced HI...

Achtung: bitte bestellen Sie immer ein Vielfaches von 3 Stück (also 3 Stück, 6 Stück, 9 Stück etc.) sonst wird im Warenkorb die Meldung "ungültige Stückzahl" angezeigt....

One piece stainless steel half-out weighing 50 grains, made for Easton's 5mm shaft family. The half-out is glued into the shaft and protrudes slightly. The point then seats against a steel shoulder rather than against the carbon or aluminium itself, ...

Achtung: bitte bestellen Sie immer ein Vielfaches von 3 Stück (also 3 Stück, 6 Stück, 9 Stück etc.) sonst wird im Warenkorb die Meldung "ungültige Stückzahl" angezeigt....

Lightweight push-in nock for Easton shafts with a 6.2 mm inside diameter, listed by Easton as nock size S. The 6.5 in the name refers to the shaft family, not to the nock. What counts is the inside diameter of 0.245 inch, or 6.2 mm. The Microlite is ...

Push-in nock for Easton shafts with a 6.2 mm inside diameter, listed by Easton as nock size S. The 6.5 in the name refers to the shaft family, not to the nock. What counts is the inside diameter of 0.245 inch, or 6.2 mm. The throat comes in the large...

Brass insert with an 8-32 thread for 6 mm shafts, adjustable in weight from 75 down to 50 grain. Brass puts weight exactly where it has the most effect, right at the front. That raises FOC without having to move to a heavier point, and it settles the...