Ready built carbon arrow from the Jet series, matched to the light draw weights of beginners and club shooters. The arrow arrives ready to shoot: fletched with 2 inch plastic vanes, fitted with a pin and a pin nock and with the point already glued in...

Aluminium pin insert for Jet series shafts with a 4.2 mm inside diameter, in three versions graded by spine. The insert glues into the rear end of the shaft and carries the pin that the nock pushes onto. The benefit of this design shows when an arrow...

Pin nock in the small size for the pin inserts of the Jet series, in white and yellow. The nock pushes onto the pin of the insert rather than being glued into the shaft. It can therefore be swapped without tools and rotated freely to set nock alignme...

Steel glue-in point for Jet series shafts with a 4.2 mm inside diameter, adjustable in weight through two break lines. The point ships at full weight. Two break lines of 10 grain each are machined into the tip, so weight can be lowered in two steps. ...

Plastic vane in 2 inch length, the same fletching used on the factory built arrows of the Jet series. Intended as a replacement after damage and for anyone building their arrows in a colour scheme of their own. Seven colours are available, so cock va...